(1)濕度控制的原理是在集中烘房。如果沒有冷空氣，只有加熱室和煙室的熱空氣在里面循環。如果有冷空氣進入，在除濕門靈活控制的情況下，只要控制冷空氣進入門的大小，除濕門必然會自行打開，房間內的潮濕空氣就會被排出。此時通過除濕門排出。

(1) The principle of humidity control is in a centralized drying room. If there is no cold air, only the hot air from the heating chamber and smoke chamber circulates inside. If cold air enters, with flexible control of the dehumidification door, as long as the size of the cold air inlet is controlled, the dehumidification door will inevitably open on its own, and the humid air in the room will be discharged. At this time, discharge through the dehumidification door.

(2)溫度控制原理根據燃料燃燒與燃料和助燃空氣量的關系，通過控制助燃空氣量、煤燃燒量和煙氣排放量，控制燃燒強度，控制溫度加熱和噴房的控制。

(2) The principle of temperature control is based on the relationship between fuel combustion and the amount of fuel and combustion air. By controlling the amount of combustion air, coal combustion, and flue gas emissions, the combustion intensity is controlled, and the temperature heating and spray chamber are controlled.

新鮮空氣從整體移動噴漆房前部吸入噴漆操作區，噴漆時氣流均勻環繞工件。噴漆霧不會飛出噴漆室范圍。過噴的漆霧在負壓作用下被吸入油膜漆霧凈化器，先經過二流油膜的截留和附著，少量漆霧被油氣分離器分離出來排放達到國家標準，漆霧去除率可達95%。

Fresh air is sucked into the spray painting operation area from the front of the mobile spray painting room, and the airflow evenly surrounds the workpiece during spray painting. Spray paint mist will not fly out of the paint booth area. The overspray paint mist is sucked into the oil film paint mist purifier under negative pressure. It first passes through the interception and attachment of the secondary oil film, and a small amount of paint mist is separated by the oil and gas separator and discharged to meet national standards. The paint mist removal rate can reach 95%.

整體移動噴漆房技術特點

Technical characteristics of the overall mobile paint spraying room

整體移動噴漆房應用粒子撞擊、慣性分離、廢氣過濾等技術原理。它利用某種礦物油形成的均勻流動的油膜來收集漆霧。采用礦物油作為捕集漆霧的介質，解決了以往用水作為介質的問題。介質造成的諸多弊端，在設備中凈化后可循環使用。該凈化裝置設計合理，效果明顯，無二次污染，設備使用壽命長。

The overall mobile paint spraying room applies technology principles such as particle impact, inertial separation, and exhaust gas filtration. It uses a uniformly flowing oil film formed by a certain mineral oil to collect paint mist. Using mineral oil as the medium for capturing paint mist solves the problem of using water as the medium in the past. The many drawbacks caused by the medium can be recycled after purification in the equipment. The purification device is designed reasonably, with obvious effects, no secondary pollution, and a long service life of the equipment.

整體移動噴漆房的制造方法

Manufacturing method of overall mobile paint spraying room

移動門架立柱和橫梁骨架采用40601.5鍍鋅方管焊接立柱門架結構。龍門立柱橫梁采用1.5mm厚鍍鋅板噴涂。移動龍門架底部兩側安裝1.5KW驅動電機、減速機和配電軸。動力分配兩端安裝主動鏈輪，動力通過鏈條傳遞到門架底部的主動移動輪上。左右各有1組驅動輪，每組有2個驅動輪?；顒?dòng)房伸縮支架由活動立式支架、橫梁和活動滑輪組成。豎向支撐采用60401.5矩形管焊接成矩形框架結構，尺寸為L3500W350，橫撐每隔750mm抽出。橫梁做成L12700W350的矩形框架結構，每750mm拉一次橫撐，橫撐之間用40201.5的矩形管做斜撐，12組垂直支撐和梁結構。尾部一套為固定支架，一套為移動支架。立式支架與橫梁內壁貼PVC布，鍍鋅壓條做壓板，支架內肋與橫梁內肋用斜撐連接消除移動框架的橫向撓度變形。本設備主要為噴漆作業提供專用環境，滿足噴漆作業對溫度、濕度、光照、空氣潔凈度等方面的要求。移動式噴漆房是一種環保型涂裝設備。

The mobile gantry column and crossbeam framework adopt a 40601.5 galvanized square tube welded column gantry structure. The crossbeam of the gantry column is sprayed with 1.5mm thick galvanized sheet. Install 1.5KW drive motors, reducers, and distribution shafts on both sides of the bottom of the mobile gantry. Active sprockets are installed at both ends of the power distribution, and power is transmitted to the active moving wheels at the bottom of the gantry through the chains. There is one set of drive wheels on each side, with two drive wheels in each group. The telescopic bracket for the activity room consists of a movable vertical bracket, a crossbeam, and a movable pulley. The vertical support adopts 60401.5 rectangular pipes welded into a rectangular frame structure, with a size of L3500W350, and the horizontal braces are pulled out every 750mm. The cross beam is made of L12700W350 rectangular frame structure, and the cross brace is pulled every 750mm. 40201.5 rectangular tubes are used between the cross braces as slant support, and 12 groups of vertical braces and beam structures are used. One set at the tail is a fixed bracket, and the other set is a mobile bracket. The vertical support and the inner wall of the beam are pasted with PVC cloth, the galvanized batten is used as the pressing plate, and the inner ribs of the support and the beam are connected with slant support to eliminate the lateral deflection deformation of the moving frame. This equipment mainly provides a dedicated environment for spray painting operations, meeting the requirements of temperature, humidity, lighting, air cleanliness, and other aspects for spray painting operations. Mobile paint booth is an environmentally friendly painting equipment.

上一篇：車間焊煙除塵器設備焊煙收集方法
下一篇：工業企業中揮發性有機廢氣(VOCs)按產生來源